Cisco PA-T3 Specifications download pdf (Page 52)

Shutting Down an Interface

PA-T3 Serial Port Adapter Installation and Configuration

8-8

Step 4 Enter the shutdown command as follows:

Router(config-if)# shutdown

Step 5 To shut down additional interfaces, enter the slot/port address (or slot/port

address/interface port for a VIP2) of each additional interface followed by the shutdown

command. When you have entered all the interfaces to be shut down, press Ctrl-Z (hold

down the Control key while you press Z) or enter end to exit conﬁguration mode and

return to the EXEC command interpreter prompt.

The example that follows is for the Cisco 7100 series, Cisco 7200 series, or

Cisco uBR7200 series routers:

Router(config-if)# interface serial 1/0

Router(config-if)# shutdown

Router(config-if)# interface serial 1/1

Router(config-if)# shutdown

Ctrl-Z

Router#

The example that follows is for a VIP2:

Router(config-if)# interface serial 1/1/0

Router(config-if)# shutdown

Router(config-if)# interface serial 1/1/1

Router(config-if)# shutdown

Ctrl-Z

Router#

The example that follows is for a Catalyst RSM/VIP2:

Router(config-if)# interface serial 1/0

Router(config-if)# shutdown

Router(config-if)# interface serial 1/1

Router(config-if)# shutdown

Ctrl-Z

Router#

Step 6 Write the new conﬁguration to memory as follows:

Router# copy running-config startup-config

[OK]

Router#

The system displays an OK message when the conﬁguration has been stored.

Step 7 Verify that new interfaces are now in the correct state (shutdown). To do so on the

Cisco 7100 series, Cisco 7200 series, or Cisco uBR7200 series routers, use the show

interfaces serial slot/port command to display the speciﬁc interface, or use the show

interfaces command, without variables, to display the status of all interfaces in the

system.

Cisco 7120 interface, followed by the type

(serial) and port adapter

number/interface port number

Router(conﬁg)# interface serial 3/0

Cisco 7140 interface, followed by the type

(serial) and port adapter

number/interface port number

Router(conﬁg)# interface serial 4/0

Table 8-1 Interface Subcommand Syntax (continued)

Platform Command Example

1 ... 51 52 53 ... 74

Comments to this Manuals

No comments

Cisco PA-T3 Specifications Page 52

Comments to this Manuals

Related products and manuals for Networking Cisco PA-T3