Cisco uBR10012 Universal Broadband Router UBR10-FAN-CAB= Specifications download pdf (Page 12)

Cisco uBR10012 Universal Broadband Router Fan Assembly Module

OL-5093-01

Remove the Cable

To replace the fan assembly cable, perform the following steps:

Step 1 Remove the front cover.

Step 2 Remove the fan assembly. See the “Remove the Fan Assembly Module” section on page 10.

Step 3 See Figure 4. Note that the cable has two “U” shaped bends that allow the cable to curve back into the

brackets and fit snugly on the bottom of the fan module enclosure.

Figure 4 Location of Fan Cable Inside the Chassis

Step 4

Reach into the chassis and disconnect the cable from the rear bracket. Push the tabs on the bracket open.

Step 5 Disconnect the cable from the front connector and remove the cable from the chassis.

Replace the Fan Assembly Cable

Note The cable has different connectors on each end.

Figure 5 Fan Cable

62337

CISCO

10000

ETHERNET

LINK

ACTIVITY

AUX

CISCO

10000

ETHER

NET

LINK

ACTIVITY

AUX

62338

Male connector Female connector

1 ... 11 12 13 14 15 16 17 18

No comments

Cisco uBR10012 Universal Broadband Router UBR10-FAN-CAB= Specifications Page 12