Cisco Wide Area Virtualization Engine 274 Troubleshooting Guide download pdf (Page 142)

100

101

1-18

Cisco Wide Area Application Services Configuration Guide

OL-26579-01

Chapter 1 Configuring Traffic Interception

Configuring WCCP on WAEs

Figure 1-3 Interception Configuration Window for WAE

Step 3

Check the current settings for the chosen device:

• To keep the current settings and to close the window, click Cancel.

• To remove the current settings, click the Remove Settings taskbar icon.

• To modify the current settings, change the current setting as described in the rest of this procedure.

• To copy the settings to other WAEs in your network, click the Copy Settings taskbar icon. The Copy

Interception Settings window opens where you can select other WAEs to which the interception

settings can be copied. You can copy all settings or you can exclude the router list and enable the

WCCP service. Click OK to copy the settings to the selected WAEs devices.

By default, WCCP is disabled on a WAE. However, as part of the initial configuration of WCCP in your

WAAS network, you should have enabled WCCP Version 2 on your WAEs (the branch WAE and the data

center WAE) as well as on the routers in the data center and branch office that will be transparently

redirecting requests to these WAEs. For information about how to perform a basic WCCP configuration

in your WAAS network, see the Cisco Wide Area Application Services Quick Configuration Guide.

1 ... 141 142 143 ... 594

Comments to this Manuals

No comments

Cisco Wide Area Virtualization Engine 274 Troubleshooting Guide Page 142

Comments to this Manuals

Related products and manuals for Networking Cisco Wide Area Virtualization Engine 274