Cisco WUMC710 User Manual download pdf (Page 78)

Advanced Configuration

Linksys WUMC710

WEP

WEP is a basic encryption method, which is not as secure as WPA or WPA2.

Key 1 Enter the WEP key of your network.

Tx Key Key 1 is the transmit key used by the media connector.

Authentication The default is Open, which uses open system authentication,

so the sender and recipient do not use a WEP key for authentication. Select

Shared to use shared key authentication, in which the sender and recipient

use a WEP key for authentication. Select Auto to allow either Open system or

Shared key authentication to be used.

Click Save Settings to apply your changes, or click Cancel Changes to cancel

your changes.

Wi-Fi Protected Setup

There are two methods available. Use the method that applies to the router

you are using.

Method #1

Use this method if your router has a Wi-Fi Protected Setup button.

Click or press the Wi-Fi Protected Setup button on the router.

Within two minutes, click the Wi-Fi Protected Setup button on the

media connector’s Wi-Fi Protected Setup screen.

After the media connector has been configured, click Close.

The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),

and Security method.

Method #2

Use this method if your router requests the PIN number of the media connector.

On the router’s Wi-Fi Protected Setup screen, enter the PIN number on

the media connector’s Wi-Fi Protected Setup screen. Then click Register

or the appropriate button. (It is also listed on the label on the bottom of

the media connector.)

On the media connector’s Wi-Fi Protected Setup screen, click OK.

After the media connector has been configured, click Close.

The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),

and Security method.

1 ... 77 78 79 ... 289

No comments

Cisco WUMC710 User Manual Page 78