Cisco WAG310G User's Guide download pdf (Page 33)

Connecting the Residential Gateway

3425-00669 Rev E 13

Connecting the Residential Gateway

Make sure that you have the following package contents:

 WAG310G

 RJ-45 Ethernet cable

 RJ-11 phone cable

 Power Adapter

 One analog touchtone telephone, if configuring VoIP service

 Access to a PSTN connection (wall jack).

Perform the following steps to connect the WAG310G.

1 Insert a standard RJ-11 phone cable (included) into the DSL port and connect the

other end to the PSTN wall jack.

2 (Optional) Connect a PC or other Ethernet device to the LAN port using a

standard RJ-45 Ethernet cable.

3 Insert a standard RJ-11 telephone cable into the PHONE 1 (FXS) port and connect

the other end to an analog touchtone telephone.

4 (Optional) You can connect the PHONE 2 (FXS) port to a second analog

telephone or a fax machine.

Note: To prevent an invalid connection to the circuit switched Telco network, do

not connect an RJ-11 telephone cable from the PHONE 1 (or PHONE 2) port on

the WAG310G to the wall jack.

5 Connect the RJ-11 phone cable (included) to the LINE (FXO) port and connect the

other end to your telephone wall jack.

6 Connect the included power adapter to the WAG310G power port, and then

plug the power adapter into an electrical outlet. The power LED on the front

panel will light up as soon as the device powers on.

7 Power on the WAG310G.

8 Follow the instructions in your owner's manual for your PC or laptop to activate

the wireless connection.

Note: A wireless connection requires a wireless-enabled notebook or a computer

with an 802.11b/g wireless network adapter installed.

1 ... 32 33 34 ... 164

No comments

Cisco WAG310G User's Guide Page 33