Cisco 3030 User Manual download pdf (Page 47)

2-19

Cisco Catalyst Blade Switch 3030 Hardware Installation Guide

OL-8389-01

Chapter 2 Switch Installation

Where to Go Next

The LED turns amber while the STP discovers the network topology and searches for loops. This process

takes about 30 seconds, and then the port LED turns green.

If the LED is off, the target device might not be turned on, there might be a cable problem, or there might

be a problem with the adapter installed in the target device. See Chapter 3, “Troubleshooting,” for

solutions to cabling problems.

Step 4 If necessary, reconfigure and restart the switch or target device.

Where to Go Next

If the default configuration is satisfactory, the switch does not need further configuration. You can use

any of these management options to change the default configuration:

• Using the Device Manager

Access the device manager through a web browser from anywhere in your network. Follow

these steps:

a. Launch a web browser on your PC or workstation.

b. Enter the switch IP address in the web browser, and press Enter. The device manager page

appears.

c. Use the device manager to perform basic switch configuration and monitoring. Refer to the

device manager online help for more information.

• Using the Command-Line Interface

The switch CLI) is based on Cisco IOS software and enhanced to support desktop-switching

features. You can fully configure and monitor the switch from the CLI. You can access the CLI either

by connecting your management station directly to the switch console port or by using Telnet from

a remote management station. Refer to the switch module command reference on Cisco.com for

more information.

• Using SNMP

You can use SNMP management applications such as CiscoWorks. You also can manage the switch

from an SNMP-compatible workstation that is running platforms such as SunNet Manager.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 71 72

No comments

Cisco 3030 User Manual Page 47