Cisco 7301 User Manual download pdf (Page 20)

Configure Global Parameters

When you first start the setup program, you must configure the global parameters. These parameters are used for controlling

system-wide settings. Complete the following steps to enter the global parameters:

Step 1 Connect a console terminal to the console port, and then boot the router.

The system boots from Flash memory. The following information appears after about 30 seconds. When you see this

information, you have successfully booted your router:

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

Rights clause at FAR sec. 52.227-19 and subparagraph

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) 7301 Software (C7301-JS-M), Experimental Version 12.2(20030103:230909) [biff 100]

Compiled Fri 03-Jan-03 16:03 by biff

Image text-base:0x600088F4, data-base:0x617F6000

cisco 7301 (NPE-G1) processor (revision A) with 245760K/16384K bytes of memory.

Processor board ID 0

SB-1 CPU at 650Mhz, Implementation 1, Rev 0.2, 512KB L2 Cache

1 slot midplane, Version 2.0

Last reset from power-on

Bridging software.

X.25 software, Version 3.0.0.

TN3270 Emulation software.

3 Gigabit Ethernet/IEEE 802.3 interface(s)

509K bytes of non-volatile configuration memory.

125440K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes).

32768K bytes of Flash internal SIMM (Sector size 256K).

Press RETURN to get started!

The first two sections of the configuration script (the banner and the installed hardware) appear only at initial system

startup. On subsequent uses of the setup facility, the script begins with a System Configuration Dialog as shown in the

following example.

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Step 2 When asked if you want to enter the initial configuration dialog and see the current interface summary, enter yes or

press Return:

Would you like to enter the initial configuration dialog? [yes]:

First, would you like to see the current interface summary? [yes]:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

No comments

Cisco 7301 User Manual Page 20