Cisco 7301 User Manual download pdf (Page 9)

Step 1 Make sure that the port adapter latch is in the locked position and the screw is tightened.

Step 2 Make sure the rack brakes are locked or the rack (1) is stabilized.

Step 3 Position the router so the front is closest to you and lift it carefully into the rack. To prevent injury, avoid any sudden

twists or moves.

Step 4 Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on both sides of the

rack.

Step 5 Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the holes on the

rack or mounting strip.

Step 6 For each bracket, insert and tighten two 12-24 x 0.5-inch screws (3) to the rack.

Two-Post Rack Installation

Figure 8 Installing the Cisco 7301 Router in a Two-Post Rack

Note Inner clearance (the width between the inner sides of the two posts or rails), must be at least 17.3 inches (43.9 cm) The

height of the chassis is 1.73 inches (4.39 cm). Airflow through the chassis is from front to back.

Step 1 Make sure that the port adapter latch is in the locked position and the screw is tightened.

Step 2 Make sure the rack brakes are locked or the rack (1) is stabilized.

Step 3 Position the router so the front is closest to you and lift it carefully into the rack. To prevent injury, avoid any sudden

twists or moves.

Step 4 Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on both sides of the

rack.

Step 5 Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the holes on the

rack or mounting strip.

Step 6 For each bracket, insert and tighten two 12-24 x 0.5-inch screws (3) to the rack.

Two-post rack

Four 12-24 x 0.5-inch screws

Screw hole for cable-management bracket

80909

CISCO 7301

SLOT 1

-2

, 2

, 5

, 4

- 6

ENABLED

X CELLS

RX CARRIER

RX ALARM

ATM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

No comments

Cisco 7301 User Manual Page 9