Cisco 7301 User Manual download pdf (Page 28)

Save the running configuration to NVRAM. See the “Save the Running Configuration to NVRAM” section on page 28. If you do

not save the configuration settings that you created in the router using configuration mode and the setup facility, your configuration

will be lost the next time you reload the router.

Save the Running Configuration to NVRAM

To store the configuration or changes to your startup configuration in NVRAM, enter the copy running-config startup-config

command at the Router# prompt:

Router# copy running-config startup-config

Using this command saves the configuration settings that you created in the router using configuration mode and the setup

facility. If you fail to do this, your configuration will be lost the next time you reload the router.

Check the Running Configuration Settings

To check the value of the settings you have entered, enter the show running-config command at the Router# prompt:

Router# show running-config

To review changes you make to the configuration, use the EXEC mode show startup-config command to display the information

stored in NVRAM.

View Your System Configuration

You can use the show version (or show hardware) and the show diag commands to display the system hardware, the software

version, the names and sources of configuration files, and the boot images. Use the show diag command to determine what type

of port adapter is installed.

For specific information on the show version, show diag, and other commands, refer to the modular configuration and modular

command reference publications in the Cisco IOS software configuration documentation set that corresponds to the software

release installed on your Cisco hardware.

Perform Complex Configurations

After you have installed your Cisco 7301 router hardware and minimally configured the system, you might need to perform

more complex configurations, which are beyond the scope of this publication.

For specific information on system and interface configuration, refer to the modular configuration and modular command

reference publications in the Cisco IOS software configuration documentation set that corresponds to the software release

installed on your Cisco hardware. These publications contain additional information on using the configure command.

Replace or Recover a Lost Password

See the Cisco 7301 Installation and Configuration Guide, Chapter 3, “Starting and Configuring the Router” for instructions.

It is possible to recover the enable or console login password. The enable secret password is encrypted and must be replaced

with a new enable secret password.

Troubleshooting Information

For system start-up troubleshooting information, see the online Cisco 7301 Router Troubleshooting Module and Cisco 7301

Router Troubleshooting and Configuration Notes.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

No comments

Cisco 7301 User Manual Page 28