Cisco ME 3400 Installation Guide download pdf (Page 8)

Refreshing the PC IP Address

For a dynamically assigned IP address, disconnect the PC from the switch, and reconnect it to the

network. The network DHCP server will assign a new IP address to the PC.

For a statically assigned IP address, change it to the previously configured IP address.

4 Managing the Switch through the CLI

After initially setting up and installing the switch in your network, you can enter Cisco IOS commands

and parameters through the CLI. Access the CLI either by connecting your PC directly to the switch

console port or through a Telnet session from a remote PC or workstation.

Other Management Options

You can use SNMP management applications such as CiscoWorks Small Network Management

Solution (SNMS) and HP OpenView to configure and manage the switch. You also can manage it

from an SNMP-compatible workstation that is running platforms such as HP OpenView or

SunNet Manager.

Step 10

These choices are displayed:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch

reboots, save it in NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

Step 11

Disconnect the switch from the PC, and install the switch in your production network. See

the “Managing the Switch through the CLI” section on page 8 for information about

configuring and managing the switch.

If you need to rerun the initial configuration dialog, see the “Resetting the Switch” section

on page 18.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Cisco ME 3400 Installation Guide Page 8