Cisco 1710 Specifications download pdf (Page 28)

Chapter 1 Introduction to Router Configuration

Saving Configuration Changes

1-10

Cisco 1710 Security Router Software Configuration Guide

78-12696-01

Undoing Commands

If you want to disable a feature or undo a command you entered, you can enter the

keyword no before most commands; for example, no ip routing.

Saving Configuration Changes

You need to enter the copy running-config startup-config command to save your

configuration changes to nonvolatile random-access memory (NVRAM) so that

they are not lost if there is a system reload or power outage. This example shows

how use this command to save your changes:

Router# copy running-config startup-config

Building configuration...

It might take a minute or two to save the configuration to NVRAM. After the

configuration has been saved, the following appears:

[OK]

Router#

% Incomplete command.

You did not enter all of the

keywords or values required by this

command.

Reenter the command followed by a

question mark (?) with no space

between the command and the

question mark.

The possible keywords that you can

enter with the command are

displayed.

% Invalid input

detected at ‘^’

marker.

You entered the command

incorrectly. The error occurred

where the caret mark (^) appears.

Enter a question mark (?).

All of the commands that are

available in this command mode are

displayed.

Table 1-3 Common CLI Error Messages (continued)

Error Message Meaning How to Get Help

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 87 88

No comments

Cisco 1710 Specifications Page 28