Cisco 3660 User Manual download pdf (Page 6)

Note The NM-NAM does not have an external console port. To access the NAM console, open a

NAM console session from the router or use Telnet or SSH over the network. The lack of an

external console port on the NM-NAM means that the initial boot configuration is possible

only through the router.

After you install the NAM, you must do the following to begin using the Traffic Analyzer application:

• Configuring the Analysis-Module Interface on the Router, page 6

• Enabling Packet Monitoring, page 7

• Accessing the NAM CLI, page 8

• Configuring the NAM Management Network Parameters, page 9

Configuring the Analysis-Module Interface on the Router

To configure the Analysis-Module interface on the router CLI:

Step 1 Enter the interface configuration mode for the NAM.

Router(config)# interface analysis-module

slot

port

Step 2 Assign an IP address by using the ip unnumbered command or by configuring a routable IP

address and subnet mask on the internal interface.

a. If you use the ip unnumbered command:

Router (config-if)# ip unnumbered FastEthernet

slot/port

b. If you use a routable IP address and subnet mask:

Router (config-if)# ip address 172.18.12.2 255.255.255.0

Note For the ip unnumbered command, make sure that a static route is configured on the router

CLI for the NAM IP address that you configure through the NAM CLI in Step 2 of the

“Configuring the NAM Management Network Parameters” section on page 9.

Note The following is a sample configuration: ip route <nam-ip-address> 255.255.255.255

Analysis-Module slot/0

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

No comments

Cisco 3660 User Manual Page 6