Cisco 7507 User Manual download pdf (Page 37)

Retrieve the Conﬁguration File for RSPs

Retrieve the saved conﬁguration and copy it to NVRAM by accessing the router through a console terminal, or

from a remote terminal.

Step 1 Enter the enable command at the EXEC prompt (>), and then enter a privileged-level password, as

follows:

Router> enable

Password:

Router#

Note The router runs from the default conﬁguration in NVRAM until the previous conﬁguration is retrieved.

Passwords conﬁgured on the previous system are not valid until they are retrieved.

Step 2 Enter the ping command followed by the name or IP address of the remote server, and then press

Return to check the connection between the router and the remote host.

Install Field Replaceable Units (FRUs)

Step 3 Enter the copy tftp startup-conﬁg

command and press Return to enter the

conﬁguration mode and specify that you

will conﬁgure the system from a network

device (instead of from the console

terminal, which is the default).

Router# copy tftp startup-config

Step 4 EntertheIPaddressornameofthe remote

host (the remote TFTP server to which

you originally saved the conﬁguration

ﬁle).

Address of remote host [255.255.255.255]?

10.1.1.1

Step 5 Enter the name of the conﬁguration ﬁle.

The default is to use the name of the

router with the sufﬁx -confg

(Router-confg in the following example).

If you speciﬁed a different ﬁlename when

you copied the conﬁguration, enter the

ﬁlename; otherwise, press Return to

accept the default.

Name of configuration file [Router-confg]?

Step 6 Before the system reloads the new

conﬁguration ﬁle in NVRAM, it displays

the instructions you entered for

conﬁrmation. If the instructions are not

correct, enter n (no), and then press

Returntocanceltheprocess.Toacceptthe

instructions, press Return, or press y and

then press Return. Output similar to the

following appears:

Configure using Router-confg from 10.1.1.1?

[confirm]

Loading Router-confg from 10.1.1.1: ! ! [OK -

1186/126927 bytes]

Warning: distilled config is not generated

[OK]

%SYS-5-CONFIG_NV: Non-volatile store

configured from Router-confg by console tftp

from 10.1.1.1

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Cisco 7507 User Manual Page 37

Comments to this Manuals

Related products and manuals for Networking Cisco 7507