Cisco 600W Specifications download pdf (Page 7)

600W DC-Input Power Supply Replacement Instructions 7

Power Supply Replacement

Figure 3 Removing and Replacing the Chassis Cover Panel

Step 3

Pull the top of the panel out about three inches, then grasp the sides of the panel and pull it

up and away from the chassis.

Step 4 To replace the cover panel, hold the sides of the panel with both hands and tilt the top of

the panel back slightly (toward you).

Step 5 Slide the guide tabs into the slots in the bottom edge of the chassis. (See Figure 3.)

Step 6 Using the guides as a pivot point, push the top half of the panel back toward the chassis

opening until the panel is ﬂush with the edges of the chassis.

Step 7 Hold the top front of the panel in place, if necessary, while you tighten the two captive

slotted screws with a 3/16-inch, ﬂat-blade screwdriver.

The chassis cover panel removal and replacement procedure is now complete.

H2920

Captive screws

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Cisco 600W Specifications Page 7