Cisco HWIC Installation Guide download pdf (Page 23)

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers

controller shdsl

To configure a controller for single-pair high-bit-rate digital subscriber line (SHDSL) mode, use the

controller shdsl command in global or controller configuration mode.

Cisco HWIC-4SHDSL and HWIC-2SHDSL

controller shdsl slot number/subslot number/port number

Cisco IAD2420 Series

controller shdsl number

Syntax Description

Command Defaults Controller number: 0

Command Modes Cisco HWIC-4SHDSL and HWIC-2SHDSL

Global configuration

Controller configuration

Cisco IAD2420 Series

Global configuration

Command History

Usage Guidelines This command is used to configure the controller mode and the controller number.

number Controller number. The valid controller number is 0.

slot number Defines the slot on the router in which the high-speed WAN interface cards

(HWIC) is installed.

subslot number Defines the subslot on the router in which the HWIC is installed.

port number Defines the port on the router in which the HWIC is installed. By default,

Cisco HWIC-4SHDSL and HWIC-2SHDSL use port number 0.

Release Modification

11.3(5)AAA This command was introduced.

12.2(8)T This command was implemented on Cisco IAD2420 series IADs.

12.4(15)T This command was introduced for the Cisco HWIC-4SHDSL and

HWIC-2SHDSL running on the Cisco 1841 router, and on the Cisco 2800

and 3800 series access routers.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

No comments

Cisco HWIC Installation Guide Page 23