Cisco HWIC Installation Guide download pdf (Page 40)

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers

show controllers shdsl

To display the status of the controller configured for single-pair high-bit-rate digital subscriber line

(SHDSL) mode, use the show controllers shdsl command in privileged EXEC mode.

Cisco HWIC-4SHDSL and HWIC-2SHDSL

show controllers shdsl slot number/subslot number/port number {brief | detailed}

Cisco IAD2420

show controller shdsl number

Syntax Description

Command Defaults Controller number

Command Modes Privileged EXEC

Command History

Usage Guidelines This command is used to display the controller mode, the controller number, and associated statistics.

Examples Cisco HWIC-4SHDSL and HWIC-2SHDSL

The following example displays the status of a Cisco HWIC-4SHDSL controller in slot 0, subslot 2, port

0 on a Cisco access router:

Router# show controllers shdsl 0/2/0 brief

Controller SHDSL 0/2/0 is UP

Hardware is HWIC-4SHDSL, rev 2 on slot 0, hwic slot 2

brief Provides a summary of the controller’s status.

detailed Provides a detailed report of the controller’s status.

number SHDSL controller number. The valid controller number for SHDSL mode

is 0.

slot number Identifies the slot on the router in which the HWIC is installed.

subslot number Identifies the subslot on the router in which the HWIC is installed.

port number Identifies the port on the router in which the HWIC is installed. By default,

the Cisco HWIC-4SHDSL and HWIC-2SHDSL use port number 0.

Release Modification

12.4(15)T This command was updated for the Cisco HWIC-4SHDSL and

HWIC-2SHDSL running on the Cisco 1841 router and on the Cisco 2800

and 3800 series access routers.

12.2(8)T This command was introduced on Cisco IAD2420 series.

1 2 ... 35 36 37 38 39 40 41 42 43 44

No comments

Cisco HWIC Installation Guide Page 40