Cisco HWIC Installation Guide download pdf (Page 41)

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers

show controllers shdsl

Capabilities: IMA, M-pair, 2/4 wire, Annex A, B, F & G, CPE termination

cdb=0x43EB384C, plugin=0x43DE9410, ds=0x43E9A1C4 base=0xB8000000

FPGA Version is REL.3.4.0, NIOSII FW:Ver 2.6, status Running

SDC-16i HW:Rev 1.2, status UP, FW:Ver 1.2-1.1.3__57, status Running

SDFE-4 HW:Rev 1.2, status UP, FW:Ver 1.1-1.5.2__001 , status Running

NIOSII Firmware image: System

SDC16i Firmware image: System

SDFE4 Firmware image: System

Number of pairs 4, number of groups configured 1

Ignored CLI cmds(0), Event buffer: in use(0), failed(0)

Group (0) is Not configured.

Group (1) info:

Type: M-pair over g.shdsl, status: Configure Firmware

Interface: ATM0/2/1, hwidb: 0x43F04EA0, UTOPIA phy 1

Configured/active num links: 2/0, bit map: 0x3/0x0

Line termination: CPE, line mode: M-pair, Annex-B, PMMS disabled

Line coding: 16-TCPAM, configured/actual rate: 4608/0 kbps

SHDSL wire-pair (0) is in DSL DOWN state

SHDSL wire-pair (1) is in DSL config state

Router#

Cisco IAD2420 Series

The following example displays the status of the controller that is configured for SHDSL mode on a

Cisco IAD2420 series IAD:

Router# show controller shdsl 0

SHDSL 0 controller UP

SLOT 3: Globespan xDSL controller chipset

Frame mode: Serial ATM

Configured Line rate: 1160Kbps

Line Re-activated 0 times after system bootup

LOSW Defect alarm: None

CRC per second alarm: None

Line termination: CPE

FPGA Revision: 9

Related Commands Command Description

controller shdsl 0 Configures the controller status and the controller number.

1 2 ... 36 37 38 39 40 41 42 43 44

No comments

Cisco HWIC Installation Guide Page 41