Cisco 7300-6T3 User Manual download pdf (Page 49)

4-13

Clear Channel 6-Port T3 (DS3) Line Card Installation and Configuration

OL-3449-02

Chapter 4 Configuring the 6T3 Line Card

Checking the Configuration

Using the show interfaces Command

The show interfaces command displays status information (including the physical slot and interface

address) for the interfaces you specify. The example that follows specifies serial interfaces.

Note The outputs that appear in this document may not match the output you receive when running these

commands. The outputs in this document are examples only.

Cisco 7304 Routers

Following is an example of the show interfaces command for Cisco 7304 routers. In this example, the

serial interfaces (0 to 5) are on a 6T3 line card in slot 5; also, the status information for interfaces 1

through 5 is omitted. (Interfaces are administratively shut down until you enable them.)

Router# show interfaces serial 5/0

Serial5/0 is up, line protocol is up

Hardware is Packet over DS3

Internet address is 50.1.1.2/8

MTU 9216 bytes, BW 44210 Kbit, DLY 200 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation HDLC, crc 16, loopback not set

Keepalive not set

Scramble enabled

Last input 15:00:13, output 15:00:13, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue :0/40 (size/max)

30 second input rate 0 bits/sec, 0 packets/sec

30 second output rate 0 bits/sec, 0 packets/sec

5 packets input, 520 bytes, 0 no buffer

Received 0 broadcasts, 101 runts, 0 giants, 0 throttles

0 parity

0 input errors, 0 CRC, 0 frame, 0 overrun,, 42 abort

5 packets output, 520 bytes, 0 underruns

0 output errors, 0 applique, 4 interface resets

0 output buffer failures, 0 output buffers swapped out

4 carrier transitions

[Additional display text omitted from this example]

1 ... 48 49 50 51 52 53 54

No comments

Cisco 7300-6T3 User Manual Page 49