Cisco IGX 8 User Manual download pdf (Page 16)

connect

MOD-16

Release 12.0(2)T

connect

To conﬁgure a data connection on the Cisco MC3810 to an IGX switch that will travel over the FTC

trunk, use the connect global conﬁguration command. To cancel the connection, use the no form of

this command.

connect interface dlci dlci ftc-trunk connection-id cid

no connect interface dlci dlci ftc-trunk connection-id cid

Syntax Description

Default

No data connection over the FTC trunk is conﬁgured.

Command Mode

Global conﬁguration mode

Usage Guidelines

This command ﬁrst appeared in Cisco IOS Release 12.0(2)T.

When conﬁguring a connection for an IP routing data connection over an FTC trunk, specify

Switch0 for the local interface value.

For this command, when entering the DLCI value, do not use either of the following DLCIs:

• The DLCI that was assigned to the FTC management DLCI using the ftc-trunk management-dlci

command

• The DLCI that was assigned to the FTC Frame Relay DLCI using the ftc-trunk frame-relay-dlci

command.

Example

The following command establishes a data connection on serial port 1:

connect Serial1 dlci 250 Serial0:0 connection-id 250

Related Commands

connect voice

encapsulation ftc-trunk

ftc-trunk frame-relay-dlci

interface Speciﬁes the interface on the Cisco MC3810 on which the connection is

conﬁgured.

dlci Speciﬁes the DLCI for the connection.

ftc-trunk Speciﬁes the Cisco MC3810 interface on which the FTC trunk was

conﬁgured.

cid Speciﬁes the connection ID.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Cisco IGX 8 User Manual Page 16