Cisco IGX 8 User Manual download pdf (Page 4)

Restrictions

MOD-4

Release 12.0(2)T

You have a choice of how to proceed from here. Choose one of the following options:

• To conﬁgure data connections over a separate FTC Frame Relay DLCI, proceed to the

“Conﬁguring the Cisco MC3810 FTC Frame Relay DLCI for Data Trafﬁc (Optional)” section on

page 5.

• To conﬁgure voice connections over a separate FTC voice DLCI, proceed to the “Conﬁguring the

Cisco MC3810 FTC Voice DLCI for Voice Connections (Optional)” section on page 8.

• To conﬁgure all your data and voice connections on the FTC management DLCI, perform the

following tasks:

ftc-trunk management-dlci dlci

[remote-management-dlci dlci]

Map the FTC trunk to an existing management data link

connection identiﬁer (DLCI).

Enter the remote-management-dlci value if there is a

public Frame Relay cloud between the Cisco MC3810

FTC port and the IGX FTM port. Enter this option only if

the local DLCI and the remote DLCI are not the same.

Note The DLCI (or the remote DLCI if conﬁgured) must

match the DLCI on the IGX switch conﬁgured using the

IGX addad command.

ftc-trunkmanagement-protocol{normal

| inverted}

Select the mode in which the management frames are sent.

Use normal mode when the Cisco MC3810 is connected

to the IGX switch. When two Cisco MC3810

concentrators are connected back-to-back, use inverted

mode on one concentrator; the other concentrator should

be set to normal mode.

Step Command Purpose

connect interface dlci dlci ftc-trunk

connection-id cid

(Optional) Conﬁgure a data connection between the

Cisco MC3810 and the IGX switch that will travel over

the FTC management DLCI.

For the ftc-trunk value, enter the interface on which the

FTC trunk was conﬁgured on. For example, if you

conﬁgured serial 0 as the FTC trunk, enter serial 0 for the

ftc-trunk value.

Note Do not enter the same DLCI that was assigned to the

FTC management DLCI using the ftc-trunk

management-dlci command.

connect voice dial-peer-tag ftc-trunk

connection-id cid

(Optional) Conﬁgure a voice connection between a voice

dial-peer and the IGX switch that will travel over the FTC

management DLCI.

The dial peer can be either a POTS dial peer or a Voice

over Frame Relay dial peer.

Repeat step 5 or step 6 for each data or voice connection over the FTC management DLCI.

Step Command Purpose

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

Cisco IGX 8 User Manual Page 4

Comments to this Manuals

Related products and manuals for Network switches Cisco IGX 8