Cisco MGC Node Manager Installation Guide download pdf (Page 17)

2-7

Installation Guide for the Cisco MGC Node Manager 2.5(2)

OL-4062-02

Chapter 2 Installing Cisco MGC Node Manager

Performing a New Installation of the Cisco MGC Node Manager

About Client Workstation Software

Client workstations must have Java 1.3 and Netscape 4.76 installed to use CiscoView as a client. (Other

browsers may work but have not been verified.) Netscape 4.76 is installed with Cisco EMF. The correct

version of Java 1.3 is packaged with CiscoView. When you launch the CiscoView server the first time,

you will be prompted to download and install the Java 1.3.1 version bundled with the

plugin-131-sparc.tar CiscoView server. Follow the instructions displayed to download and install this

plugin.

To use the CiscoView server, we also recommend that you install the latest J2EE Solaris patch cluster

which can be found at the following URL:

http://sunsolve.sun.com/pub-cgi/show.pl?target=patches/patch-access

Task 8: Install Cisco EMF 3.2

For basic installation, follow the procedure described in Chapter 2of the Cisco EMF Installation and

Configuration Guide at:

http://www.cisco.com/en/US/products/sw/netmgtsw/ps829/products_installation_and_configuration_g

uide_chapter09186a00801a8e14.html

For a management server, choose Server Installation. For a presentation server (a client), choose

Remote Client Installation. You do not need a license on a client machine.

After installing the base 3.2 version, go on to “Installing Cisco EMF Patches” section on page 2-7. If

you are using SSH for secure communications with SSH-enabled network components, continue with

Installing SSH. Finally, start the Cisco EMF Server, as described in “Starting Cisco EMF” section on

page 2-8.

Installing Cisco EMF Patches

Cisco MGC Node Manager requires Cisco EMF Service Pack 7 and 7.1. Refer to the Release Notes to

check on any additional patches required.

To install Service Pack 7 and 7.1, follow these steps:

Step 1 Determine your current Cisco EMF version and patch level:

cemf install -show

Step 2 Go to the following URL:

http://www.cisco.com/cgi-bin/tablebuild.pl/cemf-sp32-sp1

Step 3 Download CEMF 3.2 Service Pack 7 software, CEMF3.2P7.tar.Z, to a directory on your hard drive.

Step 4 Download and read the CEMF 3.2 Service Pack 7 Release Note, CEMF3.2P7DepRelNote.pdf.

Step 5 Download CEMF 3.2 Service Pack 7.1 software, CEMF3.2P71.tar.Z, to a directory on your hard drive.

Step 6 Download and read the CEMF 3.2 Service Pack 7.1 Release Note, CEMF3.2P71DepRelNote.pdf.

Step 7 Follow the patch installation instructions in the Release Note and in the Cisco EMF Installation and

Configuration Guide at the following location:

http://www.cisco.com/en/US/products/sw/netmgtsw/ps829/products_installation_and_configuration_g

uide_book09186a00801a8e04.html

1 ... 16 17 18 ... 38

No comments

Cisco MGC Node Manager Installation Guide Page 17