Cisco C8510-SRP - Switch Route Processor Troubleshooting Guide Page 427

  • Download
  • Add to my manuals
  • Print
  • Page
    / 502
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 426
13-23
ATM and Layer 3 Switch Router Troubleshooting Guide
OL-1969-01
Chapter 13 Troubleshooting ATM Router Module Connections
Troubleshooting RFC 1483 on ATM Router Module Connections
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
23 packets input, 10352 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 watchdog, 0 multicast
23 packets output, 10352 bytes, 2 underruns
2 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Step 6 Confirm the ATM router module interface and protocol are both up.
Step 7 Use the show atm vc interfaces atm command with VPI 0 and VCI 109 to confirm the configuration of
the ingress ATM interface connected to the Cisco 7500 router.
Switch# show atm vc interfaces atm 0/0/0 0 109
Interface: ATM0/0/0, Type: quad_oc12suni
VPI = 0 VCI = 109
Status: UP
Packet-discard-option: enabled
Usage-Parameter-Control (UPC): drop
Wrr weight: 2
Cross-connect-interface: ATM10/0/1, Type: arm_port
Cross-connect-VPI = 2
Cross-connect-VCI = 109
Threshold Group: 5, Cells queued: 0
Rx cells: 0, Tx cells: 0
Tx Clp0:0, Tx Clp1: 0
Rx Clp0:0, Rx Clp1: 0
Rx Upc Violations:0, Rx cell drops:0
Rx pkts:0, Rx pkt drops:0
Rx connection-traffic-table-index: 110
Rx service-category: UBR (Unspecified Bit Rate)
Step 8 Confirm the Status is up.
Step 9 Confirm that the Cross-connect-interface is the ATM router module internal interface.
Step 10 Again use the show atm vc interfaces atm command with VPI 0 and VCI 109 on the ingress ATM
interface connected to the Cisco 7500 router, to confirm that the cell and packet numbers are
incrementing.
Switch# show atm vc interfaces atm 0/0/0 0 109
Interface: ATM0/0/0, Type: quad_oc12suni
VPI = 0 VCI = 109
Status: UP
Packet-discard-option: enabled
Usage-Parameter-Control (UPC): drop
Wrr weight: 2
Cross-connect-interface: ATM10/0/1, Type: arm_port
Cross-connect-VPI = 2
Cross-connect-VCI = 109
Threshold Group: 5, Cells queued: 6
Rx cells: 15, Tx cells: 0
Tx Clp0:0, Tx Clp1: 0
Rx Clp0:15, Rx Clp1: 0
Rx Upc Violations:5, Rx cell drops:9
Rx pkts:0, Rx pkt drops:5
Rx connection-traffic-table-index: 110
Rx service-category: UBR (Unspecified Bit Rate)
Page view 426
1 ... 426 427 428 ... 502

Comments to this Manuals

No comments