Cisco RV082 - Small Business VPN Router User's Guide download pdf (Page 29)

Chapter 4

Advanced Configuration

10/100 8-Port VPN Router

DHCP > Setup > Enable DHCP Server

DHCP > Setup > DHCP Relay

Setup

Enable DHCP Server To use the Router as your network’s

DHCP server, select Enable DHCP Server. If you already

have a DHCP server on your network, remove the check

mark. Then configure the Dynamic IP settings.

Dynamic IP

Client Lease Time • The Client Lease Time is the amount

of time a network user will be allowed connection to

the Router with their current dynamic IP address. Enter

the amount of time, in minutes, that the user will be

“leased” this dynamic IP address. The range is 5-43,200

minutes. The default is 1440 minutes.

Dynamic IP Range Start/End • Enter a starting IP

address and ending IP address to create a range of

available IP addresses. The default range is 100-149.

(Make sure the Router’s LAN IP address is not in this

dynamic IP range.) For example, if the Router uses the

default LAN IP address, 192.168.1.1, then the starting

value must be 192.168.1.2 or greater.

DHCP Relay The DHCP Relay mechanism allows DHCP

clients and the DHCP server to be located on different

networks. The DHCP clients will send DHCP discover

broadcast packets to get IP addresses from the DHCP

server, and the Router will act as a DHCP Relay agent and

send DHCP unicast packets to DHCP server. To use the

DHCP Relay function, select DHCP Relay. The DHCP server

function will be automatically disabled. Then configure

the DHCP Server IP Address setting.

DHCP Server IP Address • Enter the IP address of the

DHCP server.

Static IP

You can assign a static IP address to a specific device based

on its MAC address.

Show unknown MAC addresses Click Show unknown

MAC addresses to view all devices’ IP addresses and

corresponding MAC addresses. The Unknown MAC

Addresses List appears.

Unknown MAC Addresses List

For each device, you can enter a descriptive name in the

Name field. To add an IP address and MAC address set to

the Static IP list, select Enable, and then click Apply. To

add all IP addresses and MAC addresses to the Static IP list,

click Select All.

1 ... 28 29 30 ... 111

Comments to this Manuals

No comments

Cisco RV082 - Small Business VPN Router User's Guide Page 29

Comments to this Manuals

Related products and manuals for Networking Cisco RV082 - Small Business VPN Router