Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Troubleshooting Guide download pdf (Page 9)

Send documentation comments to mdsfeedbac[email protected]

Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.2(3)

OL-14116-04

Software Download Process

switch# show module

Mod Ports Module-Type Model Status

--- ----- -------------------------------- ------------------ ------------

...

5 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 active*

6 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 ha-standby

For a Supervisor-2 module, the output might look like this:

switch# show module

Mod Ports Module-Type Model Status

--- ----- -------------------------------- ------------------ ------------

...

7 0 Supervisor/Fabric-2 DS-X9530-SF2-K9 active *

8 0 Supervisor/Fabric-2 DS-X9530-SF2-K9 ha-standby

Migrating from Supervisor-1 Modules to Supervisor-2 Modules

As of Cisco MDS SAN-OS Release 3.0(1), the Cisco MDS 9509 and 9506 Directors support both

Supervisor-1 and Supervisor-2 modules. Supervisor-1 and Supervisor-2 modules cannot be installed in

the same switch, except during migration. Both the active and standby supervisor modules must be of

the same type, either Supervisor-1 or Supervisor-2 modules. For Cisco MDS 9513 Directors, both

supervisor modules must be Supervisor-2 modules.

Caution Migrating your supervisor modules is a disruptive operation.

Note Migrating from Supervisor-2 modules to Supervisor-1 modules is not supported.

To migrate from a Supervisor-1 module to a Supervisor-2 module, refer to the step-by-step instructions

in the Cisco MDS 9000 Family CLI Configuration Guide.

Configuring Generation 2 Switching Modules

The Cisco MDS 9500 Multilayer Directors are designed to operate with any combination of Cisco MDS

9000 Generation 1 and Generation 2 modules. However, there are limitations to consider when

combining the various modules and supervisors in the Cisco MDS 9500 Series platform chassis. The

references listed in this section provide specific information about configurations that combine different

modules and supervisors.

For information on configuring Generation 2 switching modules, refer to:

http://www.cisco.com/en/US/products/ps5989/products_configuration_guide_chapter09186a0080664c6b.html

For information on port index availability, refer to:

http://www.cisco.com/en/US/products/ps5990/products_installation_guide_chapter09186a0080419599.html

For information on Cisco MDS 9000 hardware and software compatibility, refer to:

http://www.cisco.com/en/US/products/ps5989/products_device_support_table09186a00805037ee.html

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

No comments

Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Troubleshooting Guide Page 9