Cisco 3030 User Manual download pdf (Page 34)

2-6

Cisco Catalyst Blade Switch 3030 Hardware Installation Guide

OL-8389-01

Chapter 2 Switch Installation

Installing the Switch Module into the Server Chassis

For a description of the switch module, see the “Features” section on page 1-1.

Follow these steps to install the switch module into the server chassis:

Step 1 Obtain and make note of this information from your network administrator before you begin the switch

module installation:

• Switch IP address

• Subnet mask (IP netmask)

• Default gateway (router)

• Enable secret password (encrypted)

• Enable password (not encrypted)

• Telnet password

• SNMP community strings (optional)

Step 2 Select a chassis I/O module bay in which to install the switch module. Follow the prerequisites listed in

the “Dell Modular Server Chassis Architecture” section on page 2-5.

Step 3 Remove the end-cap (blank plug) from the selected bay. Store the end-cap (blank plug) for future use.

Step 4 If you have not already done so, touch the static-protective package that contains the switch module to

an unpainted metal part of the server chassis for at least 2 seconds.

Step 5 Remove the switch module from its static-protective package.

Step 6 Ensure that the release latch on the switch module is in the open position (perpendicular to the module).

(See Figure 2-2.)

Figure 2-2 Switch Module Release Latch in the Open Position

Step 7

Slide the switch module into the appropriate bay until it stops.

143473

11x

12x

13x

14x

15x

16x

Console

11x

12x

13x

14x

15x

16x

CON

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 71 72

No comments

Cisco 3030 User Manual Page 34