Cisco 3030 User Manual download pdf (Page 43)

2-15

Cisco Catalyst Blade Switch 3030 Hardware Installation Guide

OL-8389-01

Chapter 2 Switch Installation

Installing and Removing SFP Modules

Removing SFP Modules from SFP Module Slots

To remove an SFP module from a module receptacle, follow these steps:

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

Step 2 Disconnect the cable from the SFP module.

Tip For reattachment, note which cable connector plug is send (TX) and which is receive (RX).

Step 3 For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the

optical interfaces clean.

Step 4 Unlock and remove the SFP module, as shown in Figure 2-8.

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp

latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver

or other long, narrow instrument to open the bale-clasp latch.

Figure 2-8 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver

Step 5

Grasp the SFP module between your thumb and index finger, and carefully remove it from the

module slot.

Step 6 Place the removed SFP module in an antistatic bag or other protective environment.

1 Bale clasp

148379

11x

12x

13x

14x

15x

16x

onsole

11x

12x

13x

14x

15x

16x

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 71 72

No comments

Cisco 3030 User Manual Page 43