Cisco 15327 User Manual download pdf (Page 483)

100

101

A-9

Ethernet Card Software Feature and Configuration Guide, R7.2

Appendix A Command Reference

[no] pos trigger defects condition

Use this command to specify which conditions cause the associated POS link state to change. Use the

no form of the command to disable triggering on a specific condition.

Syntax Description

Defaults The default is to report all conditions. For a list of all conditions, see the list in the Syntax Description.

Command Modes Interface configuration mode (POS only)

Usage Guidelines This value is normally configured to match the setting on the peer PTE.

Note

In previous Cisco IOS releases, the pos trigger delay command was used to modify the triggering

interval. In Release 7.2, this command is not supported.

Examples In this example, interface is shortened to int.

Gateway(config)# int pos0

Gateway(config-if)# pos trigger defects all

Related Commands None

Parameter Description

condition The SONET/SDH condition that causes the link state change. The

conditions are as follows:

all—All link down alarm failures

ber_sd_b3—PBIP bit error rate (BER) in excess of SD threshold failure

ber_sf_b3—PBIP BER in excess of SF threshold failure

encap—Path Signal Label Encapsulation Mismatch failure

pais—Path Alarm Indication Signal failure

plop—Path Loss of Pointer failure

ppdi—Path Payload Defect Indication failure

pplm—Payload label mismatch path

prdi—Path Remote Defect Indication failure

ptim—Path Trace Indicator Mismatch failure

puneq—Path Label Equivalent to Zero failure

1 2 ... 478 479 480 481 482 483 484 485 486 487 488 ... 583 584

Comments to this Manuals

No comments

Cisco 15327 User Manual Page 483

Comments to this Manuals

Related products and manuals for Hardware Cisco 15327