Cisco IAD2430 User Manual download pdf (Page 60)

3-24

Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide

OL-4234-06

Chapter 3 Installing Cisco IAD2430 Series IADs

Connecting Cables

WAN and Voice Cables

Warning

For connections outside the building where the equipment is installed, the following ports must be

connected through an approved network termination unit with integral circuit protection.

FXS/T3/E3

Statement 1044

Note The following warning also applies to Cisco IAD2430 units that have an RJ-21 interface.

Warning

Before opening the unit, disconnect the telephone-network cables to avoid contact with

telephone-network voltages.

Statement 1041

Warning

This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do

not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11

port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming

call.

Statement 1042

These cables and connections are described in Table 3-4 on page 3-24 and shown in Figure 3-20 on

page 3-25.

Ta b l e 3-4 WAN and Voice Cable Selection

Port or Interface Color or Type Connected To Cable

T1/E1 WA N Light green WA N RJ-48 T1/E1 cable (not included)

T1/E1 Digital voice RJ-48C Digital PBX RJ-48 T1/E1 cable (not included)

Analog voice FXS RJ-21 Distribution panel RJ-21-to-RJ-21 straight-through cable

(not included)

WIC-2T Serial Cisco 12-in-1

serial port

connector

CSU/DSU and serial

network or equipment

Serial transition cable matching signaling

protocol (EIA/TIA-232, EIA/TIA-449,

V.35, X.21, or EIA-530) and operating

mode (DTE or DCE) (not included)

WIC-1DSU-T1/E1 WA N Light green WA N RJ-48 T1/E1 cable (not included)

VIC2-4FXO FXO RJ-11 Station side of analog PBX RJ-11 cable (not included)

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 85 86

No comments

Cisco IAD2430 User Manual Page 60