Cisco 7000 and 7507 Chassis MAS-7K Specifications download pdf (Page 11)

REVIEW DRAFT—CISCO CONFIDENTIAL

3-11

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 3 Installing a Cisco 7500 Series Router

Installing the Cisco 7507 and Cisco 7507-MX

This completes the procedure for attaching DC-input cables to the Cisco 7505 DC-input power supply,

as well as procedures required to install the Cisco 7505.

For information on how to connect cables to the RSP, see the “Making Cable Connections to the RSP”

section on page 3-32, and then proceed to the “What Do I Do Now?” section on page 3-33.

Installing the Cisco 7507 and Cisco 7507-MX

This section provides procedures for installing your Cisco 7507 and Cisco 7507-MX and for connecting

power cables to power supplies. Figure 3-7 illustrates the order of procedures to install the Cisco 7507

or Cisco 7507-MX router and connect cables. It also indicates the Cisco publications you should refer

to for more detailed information.

Figure 3-7 Installation Flowchart (Cisco 7507 and Cisco 7507-MX)

Depending on your configuration, you might need to insert additional or new processor modules in your

Cisco 7507 or Cisco 7507-MX. To insert or remove interface processors, you do not need to turn off

power to the system. However, if the system is operating, you must turn off the system power before you

insert or remove an RSP2, RSP4, or RSP8.

You need a number 1 Phillips or 3/16-inch flat-blade screwdriver to remove any fillers (blank processor

module carriers) and to tighten the captive installation screws that secure the processor module in its slot.

Whenever you handle modules, you should use an ESD-preventive wrist strap or other grounding device

to prevent ESD damage.

Make external connections

H9718

Perform an initial configuration and

create a basic configuration file. Use the

procedures in Chapter 4 “Performing

a Basic Configuration of the System.”

For more information about configuration,

refer to the Cisco IOS configuration

guides and command references.

Insert power supplies

Unpack the router

(Use

Cisco 7000 and Cisco 7507

Unpacking Instructions)

Rack-mount the router

(Use

Cisco 7000 and Cisco 7507

Rack-Mount Installation Instructions)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

No comments

Cisco 7000 and 7507 Chassis MAS-7K Specifications Page 11