Cisco 7000 and 7507 Chassis MAS-7K Specifications download pdf (Page 7)

REVIEW DRAFT—CISCO CONFIDENTIAL

3-7

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 3 Installing a Cisco 7500 Series Router

Installing the Cisco 7505

Cisco 7505 Installation Considerations

Before you install the Cisco 7505, decide where to install the router. If you intend to rack-mount the

router, proceed to the “Rack-Mounting the Cisco 7505” section on page 3-7. If you do not intend to

rack-mount the router, follow these steps to install the Cisco 7505 on a bench or tabletop:

Step 1 Make sure that your installation area is free of debris and dust.

Step 2 Make sure your path between the chassis and where you will place it is unobstructed.

Caution To prevent damage to the chassis and components, never attempt to lift or tilt the chassis with the handles

on the interface processors. These handles are not designed to support the weight of the chassis.

Step 3 Carefully place the chassis on the tabletop or bench.

Step 4 On the chassis, ensure that all captive screws (on the processor modules, and so forth) are tightened and

the components are secure.

Step 5 For an AC-input power supply: push the cable retention clip away from the power receptacle and plug

in the power cable.

Step 6 For a DC-input power supply, proceed to the “Connecting Power to the Cisco 7505 DC-Input Power

Supply” section on page 3-9; otherwise, continue with Step 7.

Step 7 Secure the cable in the power supply receptacle by pushing the cable retention clip until it snaps into

place around the cable connector.

Step 8 Connect the opposite end of the power cable to an appropriate power source.

Caution Do not turn on any power supplies until you are ready to power up the system. The interlock switch that

locks the power supply in the slot also turns on the system power.

Rack-Mounting the Cisco 7505

Before you begin the optional rack-mount installation, have the following tools and parts on hand:

• Number 1 and number 2 Phillips screwdrivers

• 1/4-inch and 3/16-inch flat-blade screwdrivers

• Tape measure

• Level (optional)

• Two chassis ears (rack brackets included with Cisco 7505)

• Four M4 x 10-mm Phillips flat-head screws to secure the ears to the chassis (included)

• Eight 10-32 x 3/8-inch slotted binderhead screws to secure the chassis ears to the mounting strips

(also called rails) in the rack

Warning

To prevent bodily injury when mounting or servicing this unit in a rack, you must take special

precautions to ensure that the system remains stable.

1 2 3 4 5 6 7 8 9 10 11 12 ... 33 34

No comments

Cisco 7000 and 7507 Chassis MAS-7K Specifications Page 7