Cisco 7000 and 7507 Chassis MAS-7K Specifications download pdf (Page 28)

REVIEW DRAFT—CISCO CONFIDENTIAL

3-28

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0

Chapter 3 Installing a Cisco 7500 Series Router

Installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576

Figure 3-17 Handling a Power Supply (Cisco 7513, Cisco 7513-MX, and Cisco 7576 AC-Input Power

Supply Shown)

Step 4 While firmly pressing the power supply faceplate so that is flush with the chassis rear panel, use a large

slotted screwdriver to tighten the captive screw that secures the power supply to the chassis frame.

Figure 3-18 Installing a Power Supply (Cisco 7513, Cisco 7513-MX, and Cisco 7576 AC-Input

Power Supply Shown)

Step 5 For AC-input power supplies—push the cable retention clip away from the power receptacle, and plug

in the power cable.

Note For DC-input power supplies, proceed to the “Connecting Power to Cisco 7513, Cisco

7513-MX, and Cisco 7576 DC-Input Power Supplies” section on page 3-29; otherwise, continue

with Step 6.

Step 6 Secure the cable in the power supply receptacle by pushing the cable retention clip until it snaps into

place around the cable connector.

Step 7 After the AC power cable is connected, reconnect the power cable at the power source, remove the tape

(if any) that you placed on the breaker switch, but do not turn on the breaker or power to the power

supply.

H5267

FAN

OUTPUT

FAIL

122306

Captive screws

FAN

OUTPUT

FAIL

FAN

OUTPUT

FAIL

POWER

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

No comments

Cisco 7000 and 7507 Chassis MAS-7K Specifications Page 28