Cisco IGX 8 User Manual download pdf (Page 5)

Configuring the Cisco MC3810 FTC Frame Relay DLCI for Data Traffic (Optional)

Cisco MC3810–IGX 8400 Interworking MOD-5

Conﬁguring the FTC Management DLCI on the Cisco IGX 8400 Switch

For Frame Relay management DLCI connections on the IGX FTM card, use the following command

syntax to add the Frame Relay management trunk connection(s) to the Cisco MC3810:

addad <slot.port> <access_device_ID> <management DLCI>

The management DLCI must match the DLCI or remote-management DLCI conﬁgured using the

Cisco MC3810 ftc-trunk management-dlci command.

Note The Cisco IGX switch command syntax differs from Cisco IOS command syntax. Items in

brackets (< >) are required command arguments. Items in square brackets ([ ]) are optional command

arguments. These commands are based on Cisco IGX System Software Release 9.1. For more

information about IGX switch conﬁguration and commands, see the Cisco WAN Switching

Command Reference.

Conﬁguring the Cisco MC3810 FTC Frame Relay DLCI for Data Trafﬁc

(Optional)

In addition to the FTC management DLCI, you can optionally conﬁgure an FTC Frame Relay DLCI

for data trafﬁc. The FTC Frame Relay data travels over the FTC management DLCI conﬁgured in

the previous section.

To conﬁgure the Cisco MC3810 FTC Frame Relay DLCI to support data connections to the

IGX 8400 switch, perform the following tasks on the Cisco MC3810 beginning in conﬁguration

mode:

Step Command Purpose

interface serial {0 | 1} If conﬁguring the FTC trunk on serial interface 0 or 1,

enter interface conﬁguration mode.

interface serial 0:x If conﬁguring the FTC trunk over the T1/E1 trunk, enter

interface conﬁguration mode, where x indicates the

channel group number.

Note Enter the same interface that you created the FTC

Trunk on. Make sure the interface is set to encapsulation

ftc-trunk.

ftc-trunk frame-relay-dlci dlci

[remote-frame-relay-dlci dlci]

Map the FTC Frame Relay DLCI to an existing Frame

Relay data-link connection identiﬁer (DLCI).

Enter the remote-management-dlci value if there is a

public Frame Relay cloud between the Cisco MC3810

FTC port and the IGX FTM port. Enter this option only if

the local DLCI and the remote DLCI are not the same.

Note Do not enter the same DLCI that was assigned to the

FTC management DLCI.

3 Repeat this procedure on each Cisco MC3810 that will send data trafﬁc to an IGX 8400

switch via an FTC Frame Relay DLCI.

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Cisco IGX 8 User Manual Page 5