Chapter 7 Configuring Frame Relay
Frame Relay
7-2
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
Before you begin configuration, be aware of the following:
• You need to enter the commands in the order shown in the task tables.
• The values shown in italic are examples. For the values shown, you should
instead enter values appropriate for your network.
• You should be familiar with Cisco IOS software and its conventions.
Note To use the verification steps described in this chapter, you must be familiar
with Cisco IOS commands and command modes. When you use the
verification steps, you need to change to different command modes. If you are
not familiar with command modes, see the “Understanding Command Modes”
section in the “Introduction to Router Configuration” chapter.
Frame Relay
This section describes how to configure a basic Frame Relay connection to the
central-site router.
These are the major tasks in configuring your router:
• Configuring Global Parameters
• Configuring Security
• Configuring the Fast Ethernet Interface
• Configuring the Serial Interface for a Frame Relay Connection
• Configuring the Point-to-Point Frame Relay Connection
• Configuring Routing Parameters
Figure 7-1 shows the configuration example used in this section.
Comments to this Manuals