Cisco 1700 Series Specifications Page 30

  • Download
  • Add to my manuals
  • Print
  • Page
    / 258
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 29
Chapter 1 Introduction to Router Configuration
Entering Configuration Mode
1-8
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
For maximum security, the passwords should be different. If you enter the same
password for both during the setup process, your router accepts the passwords but
warns you that they should be different.
An enable secret password can contain from 1 to 25 uppercase and lowercase
alphanumeric characters. An enable password can contain any number of
uppercase and lowercase alphanumeric characters. In both cases, a number cannot
be the first character. Spaces are also valid password characters; for example,
two words is a valid password. Leading spaces are ignored; trailing spaces are
recognized.
If you lose or forget your enable password, refer to the Troubleshooting chapter
in the Hardware Installation Guide that came with your router.
Entering Configuration Mode
To make any configuration changes to your router, you must be in configuration
mode. This section describes how to enter configuration mode while using a
terminal or PC that is connected to your router CONSOLE port.
To enter configuration mode:
Step 1 After your router boots up, answer no when the following question displays:
Would you like to enter the initial configuration dialog [yes]: no
Step 2 If you have configured your router with an enable password, enter the enable
command; then enter the enable password when you are prompted for it. The
enable password is not displayed on the screen when you enter it.
This example shows how to enter enable mode on a Cisco router:
Router> enable
Password: <enable_password>
Router#
Enable mode is indicated by the pound sign (#) in the prompt.
Step 3 Enter the configure terminal command to enter configuration mode, indicated by
(config)# in the prompt:
Router# configure terminal
Router (config)#
Page view 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 257 258

Comments to this Manuals

No comments