Cisco 3G MicroCell User Manual download pdf (Page 13)

AT&T 3G MicroCell™ User Manual | Other

24 25

FCC Compliance

United States FCC Compliance

This device has been tested and found

to comply with the limits for a Class B

digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to

provide reasonable protection against such

interference in a residential installation.

This equipment generates, uses, and

can radiate radio frequency energy. If not

installed and used in accordance with

the instructions, it may cause harmful

interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause

harmful interference to radio or television

reception, which can be determined by

turning the equipment OFF and ON, the

user is encouraged to try to correct

the interference by one or more of the

following measures:

» Reorient or relocate the receiving

antenna, if applicable.

» Increase the separation between the

equipment and receiver.

» Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

» Consult the service provider or an

experienced radio/television technician

for help.

Any changes or modifications not expressly

approved by Cisco Systems, Inc., could

void the user’s authority to operate the

equipment.

The information shown in the FCC

Declaration of Conformity paragraph

below is a requirement of the FCC and is

intended to supply you with information

regarding the FCC approval of this device.

The phone numbers listed are for FCC

related questions only and not intended

for questions regarding the connection or

operation for this device. Please contact

your service provider for any questions

you may have regarding the operation or

installation of this device.

Declaration of Conformity

This device complies with Part 15 of FCC

Rules. Operation is subject to the following

two conditions: 1) the device may not cause

harmful interference, and 2) the device must

accept any interference received, including

interference that may cause undesired

operation.

AT&T 3G MicroCell™

Model: MicroCell

Manufactured by: Cisco Systems, Inc.

5030 Sugarloaf Parkway

Lawrenceville, Georgia 30044 USA

Telephone: 770-236-1077

Canada EMI Regulation

This Class B digital apparatus complies with

Canadian ICES-003.

Cet appareil numérique de la class B est

conforme à la norme NMB-003 du Canada.

This device complies with RSS-132 and

RSS-133 of the Industry Canada Rules.

Operation is subject to the following two

conditions:

» This device may not cause harmful

interference.

» This device must accept any interference

received, including interference that may

cause undesired operation.

20100527 FCC Standard

RF Exposure

NOTE: This transmitter must not be

collocated or operated in conjunction

with any other antenna or transmitter.

This equipment should be installed and

operated with a minimum distance of 7.9

inches (20 cm) between the radiator and

your body.

United States

This equipment complies with FCC RF

exposure limits set forth for an uncontrolled

environment. This system has been

evaluated for RF exposure for humans in

reference to ANSI C 95.1 (American National

Standards Institute) limits. The evaluation

was based on evaluation per ANI C 95.1

and FCC OET Bulletin 65C rev 01.01. The

minimum separation distance from the

antenna/radiator to a general bystander is

7.9 inches (20 cm) to maintain compliance.

This transmitter must not be collocated or

operating in conjunction with any other

antenna or transmitter.

The availability of some specific channels

and/or operational frequency bands are

country dependent and are firmware

programmed at the factory to match the

intended destination. The firmware setting

is not accessible by the end user.

Canada

This equipment complies with IC RF

exposure limits set forth for an uncontrolled

environment. This system has been

evaluated for RF exposure for humans

in reference to Canada Health Code 6

(2009) limits. The evaluation was based on

evaluation per RSS-102 Rev 4. The minimum

separation distance from the antenna to

general bystander is 7.9 inches (20 cm) to

maintain compliance.

Disclaimer

Cisco Systems, Inc. assumes no

responsibility for errors or omissions that

may appear in this guide. We reserve the

right to change this guide at any time

without notice.

Software Use

The software incorporated in your device is

protected by copyright law and furnished

to you under a license agreement. You may

only use or copy this software in accordance

with the terms of your license agreement.

In connection with your purchase of this

product you were offered a copy of the

Software End User License Agreement,

including open source licenses and notices.

If you would like to have additional copies

of this document please go to:

http://www.att.com/MicroCellEndUserLicense.

1 2 ... 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Cisco 3G MicroCell User Manual Page 13

Comments to this Manuals

Related products and manuals for Networking Cisco 3G MicroCell