Cisco PA-E3 Specifications download pdf (Page 13)

CHAPTER

Preparing for Installation 2-1

Preparing for Installation

This chapter describes the general equipment, safety, and site preparation requirements for installing

PA-E3 port adapters.

• Parts and Tools Required, page 2-1

• Software and Hardware Requirements, page 2-2

• Safety Guidelines, page 2-3

• Compliance Information, page 2-6

Parts and Tools Required

You need the following tools and parts to install a port adapter. If you need additional equipment,

contact a service representative for ordering information.

• PA-E3 serial port adapter and one of the following:

— VIP2-15(=) if you are installing only one PA-E3 port adapter; otherwise, we recommend a

VIP2-40(=) or VIP2-50(=).

— Catalyst RSM/VIP2-15(=) if you are installing only one PA-E3 port adapter; otherwise, we

recommend a Catalyst RSM/VIP2-40(=).

— Cisco 7100 series router with at least one available port adapter slot.

— Cisco 7200 series router with at least one available port adapter slot.

— Cisco uBR7200 series router with at least one available port adapter slot.

• Cisco 75-ohm coaxial serial interface cables. (The PA-E3’s 75-ohm cables are available only

from Cisco Systems; they are not available from outside commercial vendors.)

• Number 1 Phillips screwdriver and a 3/16-inch ﬂat-blade screwdriver (for VIP2 and

Catalyst RSM/VIP2 installation only).

• Your own ESD-prevention equipment or the disposable grounding wrist strap included with all

upgrade kits, ﬁeld-replaceable units (FRUs), and spares.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

No comments

Cisco PA-E3 Specifications Page 13