Cisco PA-E3 Specifications download pdf (Page 15)

Preparing for Installation 2-3

Safety Guidelines

Note The VIP2 and Catalyst RSM/VIP2 supports online insertion and removal (OIR), but

individual port adapters do not. To replace the port adapters, you must ﬁrst remove the VIP2 or

Catalyst RSM/VIP2 from the chassis and then replace port adapters as required. OIR is supported

for port adapters in the Cisco 7100 series, Cisco 7200 series, and Cisco uBR7200 series routers.

Port adapters have a handle attached, but this handle is occasionally not shown in illustrations in this

publication to allow a full view of detail on the port adapter’s faceplate.

In the Cisco 7000 series, Cisco 7100 series, Cisco 7500 series, Cisco uBR7200 series routers and

Catalyst 5000 family switches, there are no restrictions on slot locations or sequence; however, in

the Cisco 7200 series routers, there are speciﬁc conﬁguration guidelines that must be observed for

high-bandwidth port adapters.

For speciﬁc Cisco 7200 series hardware conﬁguration information and for memory conﬁguration

guidelines for Cisco 7200 series routers, refer to the document Cisco 7200 Series Port Adapter

Hardware Conﬁguration Guidelines, which shipped with your Cisco 7200 series chassis and is also

available on the Cisco Connection Documentation, Enterprise Series CD-ROM.

To determine if your Cisco 7000 series, Cisco 7100 series, Cisco 7500 series, Cisco 7200 series, or

Cisco uBR7200 series router, or the Catalyst RSM/VIP2 is compatible with the PA-E3, use the show

version command to display the current hardware conﬁguration of the router, including the system

software version that is currently loaded and running.

You can check the version of the default ROM image by removing the board and checking the ROM

labels, or by conﬁguring the interface or system software to boot from ROM, restarting the system,

and using the show version command to check the running version.

To display the current system software version, use the show version command. In the following

example, the running system software is Release 11.1(16)CA.

Router> show version

Cisco Internetwork Operating System Software

IOS (tm) GS Software, Version 11.1(16)CA

Synced to mainline version: 11.1(10.5)

Compiled Thu 22-May-97 14:32

If your system lacks the required system software and microcode, contact a customer service

representative for upgrade information.

Safety Guidelines

The following are safety guidelines that you should follow when working with any equipment that

connects to electrical power or telephone wiring.

Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before

you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with

standard practices for preventing accidents. To see translations of the warnings that appear in this publication,

refer to the Regulatory Compliance and Safety Information document that accompanied this device.

Waarschuwing Dit waarschuwingssymbool betekent gevaar. U verkeert in een situatie die

lichamelijk letsel kan veroorzaken. Voordat u aan enige apparatuur gaat werken, dient u zich bewust

te zijn van de bij elektrische schakelingen betrokken risico's en dient u op de hoogte te zijn van

standaard maatregelen om ongelukken te voorkomen. Voor vertalingen van de waarschuwingen die

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

Comments to this Manuals

No comments

Cisco PA-E3 Specifications Page 15

Comments to this Manuals

Related products and manuals for Networking Cisco PA-E3