Cisco Small Business RV320 User Manual download pdf (Page 4)

4 Cisco RV320/RV325 Gigabit Dual WAN VPN Router Quick Start Guide

Cisco RV320 Features

Front Panel

PWR—Lit to indicate the unit is powered on and booted. Blinks when the

device is booting.

VPN—Lit green when the designated VPN tunnel is up. Blinks green when

data is being sent or received through the tunnel. Lit amber when the

tunnel is disconnected. Blinks amber when attempting to establish the

tunnel.

DMZ—Lit green when the DMZ/WAN port is configured as a DMZ.

DIAG—Blinks red when the firmware is updating. Lit red when the device

is booting.

LINK/ACT—Lit steady when a link between a port and another device is

detected. Flashes when a port is passing traffic.

GIGABIT—Lit when another device is connected to a port and a

1000 Mbps link is established. Off when the connection speed is under

1000 Mbps or no other device is attached to a port.

LAN 1-4—Lit when the LAN ports on the back panel are linked to another

device. Blinks when passing traffic.

DMZ/WAN—Lit when a device is connected to the DMZ/WAN port.

Flashes when sending or receiving data over the WAN DMZ port.

WAN—Lit when the WAN port is connected. The light is off when it is not

connected to the Internet or it is connected by using a USB dongle. Blinks

when it is sending or receiving data over the WAN connection.

USB 1 and USB 2—Lit green when the corresponding port is connected

to a device. Flashes green when the port is sending or receiving data.

RESET—Reboot or reboot and restore defaults:

• To reboot the unit and retain the current configuration, press and hold

RESET for at least 3, but no more than 10 seconds, by using a paper

clip or a pen tip.

• To reboot the unit and restore the factory default configuration, press

and hold in the RESET button for more than 10 seconds. Changes you

have made to the configuration of your device are lost.

1 2 3 4 5 6 7 8 9 10

No comments

Cisco Small Business RV320 User Manual Page 4