Cisco Small Business RV320 User Manual download pdf (Page 7)

Cisco RV320/RV325 Gigabit Dual WAN VPN Router Quick Start Guide 7

Connecting

You must connect a configuration terminal (PC) to the device by using a

LAN port. The terminal must be in the same wired subnetwork as the

device to perform the initial configuration. As part of the initial

configuration, the device can be configured to allow remote management.

To connect a computer to the device:

STEP 1 Power off all equipment, including the cable or DSL modem, the

computer, and this device.

STEP 2 Use an Ethernet cable to connect your cable or DSL modem to the

WAN port on this device.

STEP 3 Connect another Ethernet cable from one of the LAN (Ethernet)

ports to the Ethernet port on the computer.

STEP 4 Power on the WAN device and wait until the connection is active.

STEP 5 Connect the power adapter to the 12VDC port of this device.

CAUTION Use only the power adapter that is supplied with the device.

Using a different power adapter could damage the device or

cause the USB dongles to fail.

The POWER switch is on by default. The power light on the front

panel is lit when the power adapter is connected properly and the

device is finished booting.

STEP 6 Plug the other end of the adapter into an electrical outlet. Use the

plug (supplied) specific to your country.

STEP 7 Power on the computer that you connected to the LAN port in

Step 3. Your computer becomes a DHCP client of the device and

receives an IP address in the 192.168.1.xxx range.

1 2 3 4 5 6 7 8 9 10

No comments

Cisco Small Business RV320 User Manual Page 7