Cisco MC3810-APM-FXO= Datasheet download pdf (Page 52)

Configuring Voice Ports

Configuring Digital Voice Ports

VC-86

Cisco IOS Voice, Video, and Fax Configuration Guide

To create a voice class that defines the specific tone or tones to be detected and then apply the voice class

to the voice port, use the following commands beginning in global configuration mode:

Command Purpose

Step 1

Router(config)# voice class dualtone

tag

Creates a voice class for defining one tone

detection pattern. The range for the tag number is

from 1 to 10000. The tag number must be unique

on the router.

For more information about configuring voice

classes, see the “Configuring Dial Plans, Dial

Peers, and Digit Manipulation” chapter in this

configuration guide.

Step 2

Router(config-voice-class)# freq-pair

tone-id

frequency-1 frequency-2

Specifies the two frequencies, in Hz, for a tone to

be detected (or one frequency if a nondual tone is

to be detected). If the tone to be detected contains

only one frequency, enter 0 for frequency-2. The

arguments are as follows:

• tone-id—Ranges from 1 to 16. There is no

default.

• frequency-1 and frequency-2—Ranges from

300 to 3600, or you can enter 0 for

frequency-2. There is no default.

Note Repeat this command for each additional

tone to be specified.

Step 3

Router(config-voice-class)# freq-max-deviation

frequency

Specifies the maximum frequency deviation that

will be detected, in Hz. The frequency argument

ranges from 10 to 125. The default is 10.

Step 4

Router(config-voice-class)# freq-max-power

dBmO

Specifies the maximum tone power that will be

detected, in dBmO. The dBmO argument ranges

from 0 to 20. The default is 10.

Step 5

Router(config-voice-class)# freq-min-power

dBmO

Specifies the minimum tone power that will be

detected, in dBmO. The dBmO argument ranges

from 10 to 35. The default is 30.

Step 6

Router(config-voice-class)# freq-power-twist

dBmO

Specifies the power difference allowed between

the two frequencies, in dBmO. The dBmO

argument ranges from 0 to 15. The default is 6.

Step 7

Router(config-voice-class)# freq-max-delay

time

Specifies the timing difference allowed between

the two frequencies, in 10-millisecond increments.

The time argument ranges from 10 to 100 (100 ms

to 1 s). The default is 20 (200 ms).

Step 8

Router(config-voice-class)# cadence-min-on-time

time

Specifies the minimum tone on time that will be

detected, in 10-millisecond increments. The time

argument ranges from 0 to 100 (0 ms to 1 s).

Step 9

Router(config-voice-class)# cadence-max-off-time

time

Specifies the maximum tone off time that will be

detected, in 10-millisecond increments. The time

argument ranges from 0 to 5000 (0 ms to 50 s).

1 ... 51 52 53 ... 82

Comments to this Manuals

No comments

Cisco MC3810-APM-FXO= Datasheet Page 52

Comments to this Manuals

Related products and manuals for Network switch components Cisco MC3810-APM-FXO=