Cisco MC3810-APM-FXO= Datasheet download pdf (Page 56)

Configuring Voice Ports

Configuring Digital Voice Ports

VC-90

Cisco IOS Voice, Video, and Fax Configuration Guide

DTMF Timer Inter-Digit Command for Cisco AS5300 Access Servers

To configure the DTMF timer for Cisco AS5300 access servers, use the following commands beginning

in global configuration mode:

Step 10

Router(config-voiceport)# timing interdigit

milliseconds

Specifies the DTMF interdigit duration, in

milliseconds. Valid entries are from 50 to 500. The

default is 100.

Step 11

Router(config-voiceport)# timing percentbreak

percent

(Cisco MC3810 multiservice concentrators FXO

and E&M ports only) Specifies the percentage of

the break period for the dialing pulses, if different

from the default. The range is from 20 to 80. The

default is 50.

Step 12

Router(config-voiceport)# timing pulse

pulses-per-second

(FXO and E&M only) Specifies the pulse dialing

rate in pulses per second. Valid entries are from 10

to 20. The default is 20.

Step 13

Router(config-voiceport)# timing pulse-digit

milliseconds

(FXO only) Configures the pulse digit signal

duration. The range of the pulse digit signal

duration is from 10 to 20. The default is 20.

Step 14

Router(config-voiceport)# timing pulse-interdigit

(FXO and E&M only) Specifies pulse dialing

interdigit timing in milliseconds. Valid entries are

from 100 to 1000. The default is 500.

Step 15

Router(config-voiceport)# timing wink-duration

milliseconds

(E&M only) Specifies maximum wink-signal

duration, in milliseconds, for a wink-start signal.

Valid entries are from 100 to 400. The default is

200.

Step 16

Router(config-voiceport)# timing wink-wait

milliseconds

(E&M only) Specifies maximum wink-wait

duration, in milliseconds, for a wink-start signal.

Valid entries are from 100 to 5000. The default is

200.

Command Purpose

Step 1

Router(config)# controller T1

number

Configures a T1 controller and enters controller

configuration mode.

Step 2

Router(config)# ds0-group

channel-number

timeslots

range

type

signaling-type

dtmf dnis

Configures channelized T1 timeslots, which enables a

Cisco AS5300 modem to answer and send an analog

call.

Step 3

Router(config)# cas-custom

channel

Customizes E1 R2 signaling parameters for a

particular E1 channel group on a channelized E1 line.

Step 4

Router(conf-ctrl-cas)# dtmf-timer-inter-digit

milliseconds

Configures the DTMF inter-digit timer for a DS0

group.

1 ... 55 56 57 ... 82

Comments to this Manuals

No comments

Cisco MC3810-APM-FXO= Datasheet Page 56

Comments to this Manuals

Related products and manuals for Network switch components Cisco MC3810-APM-FXO=