Cisco Catalyst 6880-X Specifications download pdf (Page 81)

Distribution Layer April 2014

If the interface type is not a port-channel, then an additional command macro apply EgressQoS must also be

configured on the interface.

Step 2: If the routing protocol you are using is OSPF, you add the router neighbor authentication configuration to

the interface. The chosen password must match the neighbor peer, and you do additional OSPF authentication

configuration in a later step.

interface [interface type] [number]

ip ospf message-digest-key 1 md5 [password]

Step 3: If you want to run EtherChannel links to the core layer, configure the EtherChannel member interfaces.

Configure the physical interfaces to tie to the logical port-channel using the channel-group command. The

number for the port-channel and channel-group must match.

Also, apply the egress QoS macro that was defined in the platform configuration procedure to ensure that traffic

is prioritized appropriately.

Cisco Catalyst 4500 Series Switches do not use the logging event bundle-status command.

interface [interface type] [port 1]

description Link to {your device here} Port 1

interface [interface type] [port 2]

description Link to {your device here} Port 2

interface [interface type] [port 3]

description Link to {your device here} Port 3

interface [interface type] [port 4]

description Link to {your device here} Port 4

interface range [interface type] [port 1], [interface type] [port 2], [interface

type] [port 3], [interface type] [port 4]

no switchport

macro apply EgressQoS

carrier-delay msec 0

channel-protocol lacp

channel-group [number] mode active

logging event link-status

logging event trunk-status

logging event bundle-status

no shutdown

The Cisco Catalyst 6500 Series Switches have two egress QoS macros:

EgressQoSOneGig, which is used for Gigabit Ethernet ports, and EgressQoS, which is

used for 10-Gigabit or 40-Gigabit Ethernet ports. All other distribution layer platforms

have a single egress QoS macro, which applies to all Ethernet ports, including Gigabit

Ethernet and 10-Gigabit Ethernet.

Tech Tip

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 110 111

No comments

Cisco Catalyst 6880-X Specifications Page 81