Cisco MGC Node Manager Installation Guide download pdf (Page 20)

2-8

Cisco Media Gateway Controller Node Manager Installation Guide

OL-18332-01

Chapter 2 Installing Cisco MNM

Performing a New Installation of Cisco MNM

• If your machine does not have a DVD-ROM drive, see Table 2-5 in the Troubleshooting section for

steps on mounting a DVD-ROM drive from a remote machine.

Step 2 Write down the CiscoView server IP address, which is needed for Task 9 when you install Cisco MNM.

Step 3 Run the installation setup script by entering:

# sh setup.sh

# ./setup.sh

Step 4 Press Enter to read the license agreement.

Step 5 Enter Y to accept the license agreement and proceed with the installation, or enter N to exit the

installation.

Note • Error messages or warning messages appear if you do not have the required or recommended Server

and Client patches.

• CiscoView must use the default port number 1741. Do not modify this number during installation.

Step 6 Select one of the following installation modes:

a. Typical to select the components and install the selected components in the default location

(/opt/CSCOpx). This is the default installation mode.

b. Custom to select optional components, customize the settings, and to specify the location.

Step 7 Select CiscoView 6.1.8 to begin the installation. When the installation is complete, the following

messages display:

Software Installation Tool Completed

Possible Warnings/Errors Encountered

The warning and error messages that appear after these messages do not hinder the installation. They

only indicate that you need to take corrective actions after the installation is complete.

Your Solaris machine has successfully installed CiscoView.

For more CiscoView installation details, see the Installation and Setup Guide for CiscoView 5.4

(Standalone) at

http://www.cisco.com/en/US/products/sw/cscowork/ps4565/products_installation_guide_book09186a0

0800e19f6.html

To get the supported device list, see the User Guide for CiscoView 6.1.8 at

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_ciscoview/6.1.8/user/guide/cv618_ug.html

After installing CiscoView 6.1.8, get the support list for Signaling Link Terminals ITP-Ls and Media

Gateways (MGWs) by logging in to the CiscoView server. If your Cisco ITP-L or MGW isn't included

in the list, download the device package at

http://www.cisco.com/cgi-bin/Software/CiscoView/cvplanner.cgi

Add the device package by following the instructions provided in the readme file.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

No comments

Cisco MGC Node Manager Installation Guide Page 20