Cisco MGC Node Manager Installation Guide download pdf (Page 24)

2-12

Cisco Media Gateway Controller Node Manager Installation Guide

OL-18332-01

Chapter 2 Installing Cisco MNM

Performing a New Installation of Cisco MNM

The installation begins. Wait until the installation is complete.

This complete the installation procedure for Cisco EMF Service Packs 7, 7.1, and 7.2

Installing the Cisco EMF SSH Add-On Package

To enable SSH support on Cisco MNM running on Solaris 8 or 10, install the CEMF Crypto Add-on

Package by following these steps:

Note We recommend installing SSH on Cisco MNM and Cisco VSPT before installing on

Cisco

PGW 2200 Softswitch so that you can use the element managers to monitor the installation

process on the Cisco PGW 2200 Softswitch and other managed components.

Step 1 Download the CEMF Crypto Add-on Package Software and the CEMF Crypto Add-on Package

Installation Guide available from the network management download page at

http://www.cisco.com/cgi-bin/tablebuild.pl/cemf-addon-3des

Step 2 Under the heading, “Cisco Element Management Systems,” click CEMF Strong Cryptographic

Software.

Note Authorization is required for downloading the cryptographic software. If you do not have

authorization, you are automatically redirected to an authorization request page.

Step 3 Follow the installation instructions in the CEMF Crytpo Add-on Package Installation Guide.

Note Make sure the entry of SSH exists in the /etc/services file on the machine where Cisco MNM is

installed.

Caution Using the # character in the /etc/motd banner may cause problems in the SSH connectivity.

The # character might interfere in the scripts used in Cisco MNM. If you encounter problems

using SSH with the installation of the CEMF Crypto Add-on package, and the SSH entry in

the /etc/services file, try removing the motd banner.

Caution Do not use special characters, such as %$#@&, in the SSH password because the

CEMF

Crypto Add-on package does not support these special characters for the SSH

password.

Downloading Cisco EMF Patches

To download a Cisco EMF patch, use the following steps:

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

No comments

Cisco MGC Node Manager Installation Guide Page 24