Cisco AIRONET CB21AG Technical Information download pdf (Page 14)

Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 1.1

OL-5800-01

Installing or Upgrading Client Adapter Software

Figure 9 Setup Status Window

The installation process begins, and you are notified as each software component is installed.

Step 26 When a message appears indicating that your computer needs to be rebooted, click OK and allow your

computer to restart.

Step 27 If you are using a PI21AG card, follow the instructions in Chapter 3 of the Cisco Aironet 802.11a/b/g

Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide to insert the

PCI card.

Step 28 If the Windows Found New Hardware Wizard appears after your computer reboots, click Next, allow the

wizard to install the software for the client adapter, and click Finish.

Step 29 If your network setup does not include a DHCP server and you plan to use TCP/IP, follow these steps

for your operating system.

• Windows 2000

a. Double-click My Computer, Control Panel, and Network and Dial-up Connections.

b. Right-click Local Area Connection x (where x represents the number of the connection).

c. Click Properties.

d. In the Components Checked Are Used by This Connection field, click Internet Protocol

(TCP/IP) and Properties.

e. Choose Use the following IP address and enter the IP address, subnet mask, and default

gateway address of your computer (which can be obtained from your system administrator).

f. Click OK to close each open window.

1 ... 13 14 15 ... 26

No comments

Cisco AIRONET CB21AG Technical Information Page 14