Cisco SPA2102-R1 User Manual download pdf (Page 8)

www.joip.com

Step II: Connect your Linksys Phone Adapter

1. Connect the phone: Connect a telephone to “PHONE 1” of the two phone ports (as shown in the

diagram below) on the Linksys;

2. Connect to the router or switch: Use the Ethernet cable provided in the packaging and connect

the “INTERNET” port (as shown in the diagram below) on the Linksys to a spare Ethernet port on

your router (or the Ethernet switch or hub as described in Step I);

3. Connect the power: Connect the power cord to the receptacle on the Linksys marked “POWER”

(as shown in the diagram below), and the power adapter to an electrical outlet.

Step III: Start making and receiving IP phone calls

1. Wait for the “POWER” and “PHONE” LEDs on the Linksys to stop blinking. It should only take a

few minutes. Once the LEDs are solidly lit, pick up the telephone receiver and verify that you

hear a dial tone;

2. Once you hear a dial tone, you are ready to make and receive calls.

When placing calls always use 10-digit dialing such as 210-555-1212 (area code + number) even if

it is a local number.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Cisco SPA2102-R1 User Manual Page 8