Cisco MGC Node Manager Installation Guide download pdf (Page 21)

2-9

Cisco Media Gateway Controller Node Manager Installation Guide

OL-18332-01

Chapter 2 Installing Cisco MNM

Performing a New Installation of Cisco MNM

Note If you are using CiscoView, be sure to install the CiscoView security module after installing

Cisco MNM. See the “Task 10: Install the CiscoView Security Module” section on page 2-19.

Task 8: Install Cisco EMF 3.2

Follow the procedures below to install Cisco EMF 3.2 on a standalone system or on both machines

(Management server and Presentation server) in a distributed configuration.

For more information on the Cisco EMF 3.2 installation, see the Cisco Element Management Framework

Installation and Administration Guide at

http://www.cisco.com/en/US/docs/net_mgmt/element_manager_system/3.2_service_pack_7/installatio

n/guide/3_2p7adm.pdf

Installing on the Management Server

Step 1 Log in as the root user on the machine where Cisco EMF is to be installed.

Step 2 Insert the Cisco EMF 3.2 Service Pack 7, CD #1 in the CD-ROM drive.

Step 3 Change the folder using the following command:

# cd /cdrom/cdrom0

Step 4 Invoke the Cisco EMF installation script using the following command:

# ./cemfinstall

A menu listing the Cisco EMF installation options displays.

Step 5 Select the Cisco Element Manager Framework - Server option, and press Enter.

Step 6 Accept the default location for the installation (<CEMF_ROOT>) and press Enter.

Step 7 Accept the default location (/opt/Backup) and press Enter.

Note You should specify a separate disk to gain better performance.

Step 8 Choose the hostname, and then press Enter.

Note If the there are more than one hostnames, choose the correct hostname. If the correct hostname

is not listed in the menu, press Enter. Then enter the desired hostname and press Enter.

Step 9 Press Enter to verify that the setup information is correct.

Step 10 Enter y to accept the default DNS domain and press Enter.

Note To change the default DNS domain, enter n and press Enter. Then specify the DNS domain and

press Enter.

Step 11 Enter y and press Enter to run the FlexLM daemon, which is provided with Cisco EMF.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

No comments

Cisco MGC Node Manager Installation Guide Page 21