Cisco SCE 1000 and Technical Information download pdf (Page 19)

The above SCE 1000 port parameters are fixed and are not configurable.

Step 1 Plug the RS-232 serial cable provided with the SCE 1000 into the CON port on the front panel of the SCE 1000.

Step 2 Connect the other end of the serial cable (with an attached DB-9 connector) to the VT100 compatible local

(serial) terminal.

Step 3 At the console. press Enter several times until the Cisco logo appears on the local terminal and the setup

configuration dialog is entered.

--- System Configuration Dialog ---

At any point you may enter a question mark ‘?’ followed by ‘Enter’ for help.

Use ctrl-C to abort configuration dialog at any prompt.

Use ctrl-Z to jump to the end of the configuration dialog at any prompt.

Default settings are in square brackets ‘[]’.

Would you like to continue with the System Configuration Dialog? [yes/no]: y

Step 4 Type y and press Enter.

The system configuration dialog begins.

Initial System Configuration

Upon initial connection to the local terminal, as described above, the system configuration wizard automatically runs to

guide the user through the entire setup process. The wizard prompts for all necessary parameters, displaying default

values, where applicable. You may accept the default values or define other values.

With the exception of the time settings, which take effect immediately when entered, the new configuration is applied and

saved only at the end of the dialog when approved by the user. Therefore, if the setup dialog is aborted, no change takes

place in the configuration, other than time settings (if entered).

When the dialog is complete, you may review the new configuration before applying it. The system displays the

configuration, including parameters that were not changed. The system also displays any errors that are detected in the

configuration. When the configuration is satisfactory, you may apply and save the new configuration.

The following table lists all the parameters included in the initial configuration. It is recommended that you obtain values

for any parameters that you will configure at this time before beginning the setup.

Note

For further information regarding any configuration step or specific parameter, refer to the relevant section in the Cisco

SCE 1000 2xGBE Software Configuration Guide.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 57 58

No comments

Cisco SCE 1000 and Technical Information Page 19