Cisco SCE 1000 and Technical Information download pdf (Page 54)

8 Troubleshoot Startup Problems

SCE 1000 Operational Status

The following table lists the operational states of the SCE 1000. The Status LED on the SCE 1000 Front Panel reflects

the current SCE 1000 operational status. The operational status can be displayed using CLI command show system

operation-status.

Table 8-1 SCE 1000 Operational States

SCE 1000

Operational

Status

Description Status LED State

Booting Initial state after reset Orange

Operational SCE 1000 becomes operational after completing the following

process:

• Boot is completed

• Power self-tests are completed without failure

• Platform configuration is applied

Flashing green

Warning SCE 1000 is fully operational (as above) but one of the

following occurred:

• Line ports (GBE ports) to the link are down

• Management port link is down

• Temperature raised above threshold

• Voltage not in required range

• Fans problem

• Power supply problem

• Insufficient space on the disk

Note: If the condition that caused the SCE 1000 to be in

Warning state is resolved (for example, link is up) the SCE

1000 reverts to Operational state.

Flashing orange

Failure System is in Failure state after Boot due to one of the following

conditions:

• Power on test failure.

• Three abnormal reboots in less than 20 minutes

• Platform configured to enter Failure mode consequent to

failure-induced reboot (this is configurable using CLI

command).

Note: Depending on the cause of failure, the management

interface and the platform configuration may or may not be

active/available.

Red

1 2 ... 49 50 51 52 53 54 55 56 57 58

No comments

Cisco SCE 1000 and Technical Information Page 54