Cisco 600W User Manual download pdf (Page 6)

6 600W AC-Input Power Supply and Fan Tray Replacement Instructions

Prerequisites

Before you begin this installation, review the safety guidelines in this section to avoid injuring

yourself or damaging the equipment. This section also provides a list of the tools that you need to

perform this replacement.

Safety Guidelines

When working with any electrical equipment, the following guidelines will help to ensure your

safety and protect the equipment. This list is not inclusive of all potentially hazardous situations, so

be alert.

• Never try to lift an object that is too heavy for you to lift safely by yourself.

• Keep tools and chassis components away from walk areas.

• Do not work alone when potentially hazardous conditions exist.

• Do not wear loose clothing, jewelry (including rings and chains), or other items that could get

caught in the chassis. Fasten your tie or scarf and sleeves.

• Never install equipment that appears damaged.

• Before beginning any procedures requiring access to the chassis interior, locate the emergency

power-off switch for the room in which you are working.

• Disconnect all power and external cables before moving a chassis.

• Never assume that power has been disconnected from a circuit; always check.

• Do not perform any action that creates a potential hazard to people or makes the equipment

unsafe.

• Carefully examine your work area for possible hazards such as moist ﬂoors, ungrounded power

extension cables, and missing safety grounds.

In addition, use the guidelines that follow when working with any equipment that is connected to

telephone wiring or other network cabling:

• Never install telephone wiring during a lightning storm.

• Never install telephone jacks in wet locations unless the jack is speciﬁcally designed for wet

locations.

• Never touch uninsulated telephone wires or terminals unless the telephone line has been

disconnected at the network interface.

• Use caution when installing or modifying telephone lines.

Opening the chassis and removing the power harness cover exposes the power distribution wiring

on the backplane. If the power is not shut down, the high current present on the backplane becomes

a hazard. Also, removing the cover compromises the electromagnetic interference (EMI) integrity

of the system. Therefore, always make sure that the system power switch is turned off before

removing the chassis cover panel or replacing any internal components.

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

No comments

Cisco 600W User Manual Page 6